Vertical Tensile Tester LVTT-T2012

Introduction

The Vertical Tensile Tester features a maximum capacity of 1KN, equipped with force sensors, to help measure the durability of the material being tested. It is basic and crucial testing equipment which tests the durability of any material. Its ability to connect to a computer with port and touch screen allows it to be easy to use. It’s tensile tester can test metal, rubber, plastic, textile, leather, paper composite materials, etc.

This test equipment is designed to meet the rigorous requirements of modern laboratory operations, ensuring high precision, reliability, and ease of use for various experimental applications.

Applications

Our Vertical Tensile Tester  is built for the test of tensile strength of various materials and has servo motor drive. Our tensile tester mainly measures the tensile, compression, adhesion, peeling, tearing, etc.

Specifications

Capacity ()	5KN (10N, 20N, 50N, 100N, 200N, 500N, 1KN, 2KN, 5KN sensors available)
Control Method	Full computer control mode, powerful software
Unit of Force	N, kN, gf, kgf, lbf, kP, tf(SI), tf (long)...
Unit of Length	mm, cm, Inch, m, km, um..
Force Resolution	1/1,000,000
Sensor Accuracy	3/1000,000
Machine Accuracy	Level 5
Stroke Resolution	1/1,000,000 mm
Effective Stroke	850 mm
Speed Range	0.01~500 mm/min; (Customizable)
Test Space Diameter	Φ140 mm
Shutdown Mode	Overload stop, emergency stop key, automatic stop for test piece destruction, automatic stop for upper and lower limit setting
Machine Power	Servo motor drive
Dimensions	52 × 60 × 152 cm
Machine Net Weight	55 KG
Power	400W
Power Supply	220V 50 ~ 60HZ
Machine Accessories	1 communication cable, 1 software
Optional Accessories	Tensile jig, compression jig, etc.; (according to different test standards to buy different jigs)

Features

Bench top design

Flexible Data output unit

Highly efficient

User-friendly

FAQs

1. Can I export test data to a or computer?

Yes, Vertical Tensile Tester come with or ports that allow exporting test data to external storage or PCs. Some models have built-in memory for data storage, while others require direct connection to software installed on a computer. Exported data can include test parameters, force-extension curves, and detailed analysis reports, depending on the software used.

2. What safety features are included in the Vertical Tensile Tester ?

Safety features generally include overload protection, emergency stop buttons, limit switches to prevent over-travel, and protective covers for moving parts. These features ensure operator safety and prevent damage to the machine. Additionally, some models feature auto-stop functions that halt testing when a sample break is detected or when preset force/displacement limits are exceeded.

3. How long does a typical test cycle take?

A standard tensile test cycle may take anywhere from 30 seconds to several minutes, depending on the material, test speed, and elongation. Thin films and soft materials generally test quicker, while tougher materials may require slower speeds for accurate data capture. Test duration also depends on whether pre-load, hold time, or other conditions are part of the test protocol.

4. Can I test samples of various dimensions?

Yes, Vertical Tensile Tester is designed to accommodate a variety of sample sizes. The crosshead travel range and adjustable grips allow testing of short or long specimens. However, it is important to ensure that the sample falls within the specified length and thickness range mentioned in the technical specifications. For unusually shaped or large samples, custom fixtures may be needed.

5. Is operator training required to use the machine effectively?

Yes, basic operator training is recommended for safe and effective use of the machine. Training covers sample preparation, machine setup, software operation, safety protocols, and data interpretation. manufacturers provide user manuals, video tutorials, or even on-site training. Trained operators are better equipped to troubleshoot issues and maintain test consistency.