Rotary Evaporator LRE-T2014

Introduction

Rotary Evaporator offers rotating speeds from 10 to 140 rpm for efficient liquid removal. It includes motorized lift for easy height adjustment during the process. Features integrated vacuum system for efficient solvent recovery and reduced boiling point. The adjustable speed control offers flexibility for different evaporation requirements. Easy-to-clean components reduce downtime and ensure consistent performance over time. This equipment is essential for solvent evaporation and concentration processes in chemical, pharmaceutical, and food laboratories. It features efficient heat transfer and vacuum control to ensure optimal distillation results while protecting sensitive samples.

Applications

Our Rotary Evaporator efficiently separates solvents through controlled distillation, ensuring reliability, making it ideal for chemical synthesis, pharmaceutical, and academic research laboratories.

Specifications

Ambient Temperature	5°C to 35°C
Host Speed Regulation	Stepless speed regulation, AC
Rotating Speed	10 to 140 rpm
Rotating Motor	40 W
Temperature Control	Digital display, room temperature to 99°C
Rotating Bottle	5/6 L
Receiving flask	3L
Evaporation Capacity	Water ≥2, Ethanol ≥4 L/hour
Bath Pot Material	Stainless steel
Bath Size	Ø300×170 mm
Lifting Function	Electric (automatic) lifting
Lifting Height	0 to 150 mm
Power Consumption	1.65 kW
Power Supply	Single phase 220V/50-60Hz
Dimensions	860mm×500mm×1000mm

Features

High-quality glass components

Adjustable rotation speed

Efficient solvent evaporation process

Durable, corrosion-resistant design

Reliable high vacuum performance

FAQs

1. What vacuum level is appropriate for operating a rotary evaporator?

The appropriate vacuum level depends on the boiling point of the solvent being evaporated. For most common solvents, a vacuum level between 10-50 mbar is suitable. Lower boiling point solvents (such as ethanol) require higher vacuum (lower pressure), while higher boiling point solvents may need lower vacuum. It's important to adjust the vacuum level gradually to prevent sample bumping and ensure efficient evaporation.

2. How to prevent sample bumping during rotary evaporation?

To prevent sample bumping, you can: 1) Use a bumping tube or anti-bumping granules in the evaporating flask; 2) Control the heating bath temperature to avoid rapid temperature increase; 3) Adjust the rotation speed to ensure gentle mixing of the sample; 4) Gradually increase the vacuum level instead of applying full vacuum immediately; 5) Ensure the evaporating flask is properly centered and balanced.

3. How often should the rotary evaporator's seals be replaced?

The frequency of seal replacement depends on usage frequency, the type of solvents used, and maintenance practices. Under normal usage with non-corrosive solvents, seals should be inspected every 3-6 months and replaced if signs of wear, leakage, or reduced vacuum performance are observed. For corrosive solvents, more frequent inspection and replacement (every 1-3 months) may be necessary to maintain vacuum integrity.

4. Can the rotary evaporator be used for heat-sensitive samples?

Yes, the rotary evaporator can be used for heat-sensitive samples by utilizing the vacuum system to lower the solvent's boiling point, thus reducing the required heating temperature. For highly heat-sensitive samples, additional measures such as using a cold trap, lowering the heating bath temperature further, or reducing the rotation speed can help protect the sample from thermal degradation while maintaining efficient evaporation.

5. How to clean the rotary evaporator after use?

After use, follow these cleaning steps: 1) Turn off the heating bath and vacuum system, and allow the equipment to cool down; 2) Remove and empty the receiving flask; 3) Rinse the evaporating flask and condenser with an appropriate solvent (compatible with the sample residue); 4) For stubborn residues, use a soft brush or ultrasonic cleaner (if compatible with glass components); 5) Dry all components thoroughly before reassembly; 6) Wipe the exterior of the equipment with a clean, damp cloth.