Single Automated Stainer

Introduction

A single automated stainer is used for automated staining of slides in laboratory workflows. It is widely used in pathology and clinical diagnostics. The system ensures consistent staining quality. It solves manual staining variability. By automating staining cycles, it improves reproducibility.

Standards

ISO 15189:2022-Medical laboratories-Requirements for quality and competence

ISO/TS 23824:2024-Medical laboratories-Guidance on application of ISO 15189 in anatomic pathology

Complies with the above standards, but is not limited to them.

Features

1. Integrated waste tray keeps the cutting area clean.

2. Orientation and trimming functions align the specimen block.

3. Precise specimen orientation improves section quality.

4. Smooth advance and retraction reduce chatter and specimen damage.

5. Precise section thickness control produces consistent, thin cuts.

FAQ

What are the main applications of the Single Automated Stainer?

The Single Automated Stainer is used in histology and pathology to prepare tissue sections, process samples and handle slides for microscopic diagnosis. It supports hospital laboratories, research and teaching where thin, consistent sections and clean staining are required.

Which standards and regulations apply to the Single Automated Stainer?

The equipment is designed with reference to IEC 61010 electrical safety and relevant GB/T standards for histology laboratory equipment, with workflows following standard histopathology practice. Compliance documentation can be provided on request.

What warranty comes with the Single Automated Stainer?

The system is covered for 12 months after shipment, including the main mechanism and electrical controls. Replaceable consumables and routine service items are not part of the warranty. Faults caused by improper installation outside the manual or unauthorised modification are not covered.

Will staff need special training?

Routine operation is straightforward and is covered in the user manual, including setup, daily use and basic maintenance. Staff with basic laboratory experience can run it after a short familiarisation. We provide remote guidance and can arrange on-site training where required.

What is the typical lead time for order delivery?

Standard models require 7-30 working days. In-stock units can ship within 3-7 working days. Custom configurations or large built-to-order systems may require additional time, and we confirm the exact schedule before order confirmation.

How often should the Single Automated Stainer be calibrated?

Regular calibration keeps measurements within the stated accuracy; an annual check is typical, with shorter intervals for heavy or regulated use. Reference standards and procedures are described in the manual. We can quote calibration with certificates.

Where do we get replacement parts?

Common consumables and standard spare parts are available through our service channel and are not locked to proprietary formats. Quote the model and serial number when ordering so the correct items are supplied. Lead time for standard parts is usually short.

Are options or configurations available?

Customisation is supported for many installations, including tailored parameters, connections and accessories. Our team reviews the requirement and confirms feasibility and lead time in advance. We avoid committing to options that cannot be delivered reliably.

Do you provide on-site installation?

The unit is delivered ready for set-up, with clear commissioning steps in the manual. We provide remote technical support during installation. For larger or regulated systems, a factory-trained engineer can attend on site on request.

What should be avoided when using the Single Automated Stainer?

Do not cut with damaged blades, force the mechanism or handle reagents without protection. Change blades carefully, clean the bath and fix tissue properly. Follow laboratory safety rules.