Gel Dryer

Introduction

Gel Dryer provides 440 x 360 mm gel drying area which contributes to convenience and efficiency of dryer. They deliver uniform heat distribution ensuring efficient and consistent results. Their built-in temperature control allows for optimal settings tailored to various gel types. They feature an easy-to-read LED display for monitoring progress during drying cycles. Gel Dryer are suitable for laboratories and research facilities focusing on gel electrophoresis.

Standards

Complies with the above standards, but is not limited to them.

Features

1. Vent or exhaust removes moist air.

2. Easy-to-clean surfaces resist residues.

3. Bench and floor models fit different spaces.

4. Adjustable shelves or trays suit different loads.

5. Over-temperature protection safeguards samples.

FAQ

What is the Gel Dryer mainly used for?

The Gel Dryer is used to remove moisture from samples, parts or products under controlled conditions. It supports laboratory, food, chemical, pharmaceutical and industrial preparation work.

What standards does the Gel Dryer comply with?

The unit is designed with reference to IEC 61010 electrical safety and relevant GB/T standards for drying equipment. Procedures should follow the relevant method. Compliance documentation can be provided on request.

What warranty comes with the Gel Dryer?

The complete unit carries a 12-month warranty from delivery, covering the main body, core components and controller against manufacturing defects. Consumables and wearing parts such as filters, seals and probes are not covered. Damage from misuse, improper power or unauthorised repair is excluded, and extended warranty can be quoted.

How easy is the Gel Dryer to use?

The controls are designed for regular laboratory use, so most users become confident after a brief introduction. The manual walks through each step, and common settings can be saved for repeat work. Online or on-site training is available if the site requires it.

How long does delivery usually take?

Standard models require 7-30 working days. In-stock units can ship within 3-7 working days. Custom configurations or large built-to-order systems may require additional time, and we confirm the exact schedule before order confirmation.

Is calibration included?

Factory calibration is included, and routine verification is recommended every 6 to 12 months using suitable reference materials. Regulated sites may require more frequent checks and documented records. Calibration support and certificates can be provided on request.

Where do we get replacement parts?

The instrument uses standard, widely available consumables rather than special locked items. Replacement parts, accessories and consumables can be ordered from us against the model number. We keep common service parts in stock for prompt supply.

Can it be adapted to our requirements?

Customisation is supported for many installations, including tailored parameters, connections and accessories. Our team reviews the requirement and confirms feasibility and lead time in advance. We avoid committing to options that cannot be delivered reliably.

Is installation and commissioning included?

Standard installation is straightforward and supported by the manual and start-up documentation. Our technical team can guide staff remotely through checks and validation. On-site commissioning is available as a quoted service.

What should be avoided when using the Gel Dryer?

Do not dry flammable or heat-sensitive items beyond the design, overload the chamber or block airflow. Use the correct temperature. Follow laboratory safety rules.