Flash Point Tester

Introduction

A flash point tester measures the lowest temperature at which vapors ignite. It is widely used in petroleum and chemical industries. The system ensures safety evaluation. It solves fire hazard uncertainty. By providing controlled heating, it supports flammability testing.

Standards

ISO 2719:2025-Determination of flash point-Pensky-Martens closed cup method

ASTM D93-25-Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester

ISO/TR 29662:2020-Petroleum products and other liquids-Guidance for flash point and combustibility testing

Complies with the above standards, but is not limited to them.

Features

1. Sample cups and accessories follow standard dimensions.

2. Precise heating and detection give repeatable flash-point results.

3. Over-temperature and flame safety protection included.

4. Cooling and ventilation functions speed turn-around.

5. Open-cup or closed-cup modes match different specifications.

FAQ

What are the main applications of the Flash Point Tester?

The Flash Point Tester is used to determine the lowest temperature at which a sample's vapours ignite briefly. It indicates flammability and supports safety classification, fuel handling and quality control for petroleum products, solvents and chemicals.

What standards does the Flash Point Tester comply with?

The tester is designed with reference to applicable ASTM, ISO and GB/T flash-point methods, such as Pensky-Martens or Cleveland open cup, and IEC 61010 electrical safety. Procedures must follow the relevant method. Compliance documentation can be provided on request.

What warranty comes with the Flash Point Tester?

We provide a 12-month limited warranty on the instrument and its key working parts. Consumables, accessories and parts subject to normal wear are excluded, as is damage caused by incorrect operation or maintenance. An extended service plan is available on request.

Will staff need special training?

Routine operation is straightforward and is covered in the user manual, including setup, daily use and basic maintenance. Staff with basic laboratory experience can run it after a short familiarisation. We provide remote guidance and can arrange on-site training where required.

How long does delivery usually take?

Standard models require 7-30 working days. In-stock units can ship within 3-7 working days. Custom configurations or large built-to-order systems may require additional time, and we confirm the exact schedule before order confirmation.

How often should the Flash Point Tester be calibrated?

The unit is calibrated and tested before delivery. For ongoing accuracy, verify it against traceable reference standards every 6 to 12 months, or according to the laboratory quality schedule. We can arrange calibration service and certificates where required.

Are the consumables universal or proprietary?

Filters, seals, probes and similar items are standard and can be supplied through our channel. Customers may also source equivalent items that meet the specification. Provide the model and serial number to confirm compatibility before ordering.

Can it be adapted to our requirements?

Yes, common options include different ranges, voltages, accessories, interfaces and capacity or size configurations. We confirm feasibility, specifications and any delivery impact before order confirmation. Custom requirements are reviewed case by case.

Is installation and commissioning included?

The unit is delivered ready for set-up, with clear commissioning steps in the manual. We provide remote technical support during installation. For larger or regulated systems, a factory-trained engineer can attend on site on request.

What should be avoided when using the Flash Point Tester?

Do not test samples that react dangerously near ignition, leave the test unattended or use the wrong cup method. Work away from ignition sources and ventilate. Follow laboratory safety rules.