Density Tester

Introduction

A density tester is used to measure the density of liquids and solids in laboratory and industrial applications. It is widely used in chemical analysis, petroleum testing, and quality control. The system provides accurate and repeatable density measurements for various materials.

Standards

ISO 15212-1:2018-Oscillating-element density meters-Laboratory instruments

ISO 15212-2:2018-Oscillating-element density meters-Process instruments for homogeneous liquids

Complies with the above standards, but is not limited to them.

Features

1. Calibration and self-check functions support accuracy.

2. Durable construction suits routine laboratory use.

3. Accessories and consumables are available through our channel.

4. Clear labelling and colour-coded controls reduce operator error.

5. Easy cleaning and maintenance extend service life.

FAQ

What are the main applications of the Density Tester?

The Density Tester is used for a defined laboratory measurement, preparation or processing task. It supports analytical, quality-control, research, clinical or industrial work where consistent, repeatable results are required.

Which standards and regulations apply to the Density Tester?

The instrument is designed with reference to IEC 61010 electrical safety, the applicable international standard for the measurement or process and relevant GB/T standards. Procedures should follow the relevant method. Compliance documentation can be provided on request.

What warranty comes with the Density Tester?

The complete unit carries a 12-month warranty from delivery, covering the main body, core components and controller against manufacturing defects. Consumables and wearing parts such as filters, seals and probes are not covered. Damage from misuse, improper power or unauthorised repair is excluded, and extended warranty can be quoted.

Will staff need special training?

Routine operation is straightforward and is covered in the user manual, including setup, daily use and basic maintenance. Staff with basic laboratory experience can run it after a short familiarisation. We provide remote guidance and can arrange on-site training where required.

How long does delivery usually take?

Standard models require 7-30 working days. In-stock units can ship within 3-7 working days. Custom configurations or large built-to-order systems may require additional time, and we confirm the exact schedule before order confirmation.

Does the Density Tester need calibration or verification?

Factory calibration is included, and routine verification is recommended every 6 to 12 months using suitable reference materials. Regulated sites may require more frequent checks and documented records. Calibration support and certificates can be provided on request.

Are consumables and spare parts easy to obtain?

No proprietary consumable contract is required; standard parts are available from us and common laboratory suppliers. Our service team can supply a recommended parts list for the model. Most routine spares are held for quick delivery.

Can it be adapted to our requirements?

A range of options is available to match the application, such as alternative settings, fittings, data outputs or power supply. We confirm each option and its effect on price and schedule up front. Larger custom builds can be discussed.

How is the Density Tester commissioned?

Standard installation is straightforward and supported by the manual and start-up documentation. Our technical team can guide staff remotely through checks and validation. On-site commissioning is available as a quoted service.

What maintenance and safety points matter?

Do not use the instrument outside its rated range or intended samples, skip calibration or ignore safety and maintenance instructions. Follow the operating manual and laboratory safety rules.